What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Wing stiffener overlap

unitink72

Well Known Member
One you start cleco'ing on the top wing skins for the first time, the long and short stiffeners go on too. I just can't figure out which one should go on top of the other. From the diagram you can't tell. Maybe it doesn't matter?

Las0zTo.png
 
It does matter. Look at the pre-punched holes and you will see one side offset so that on the overlap the rivet holes line up.

Carl
 
Back
Top