What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

marking spinner hole.

LUKLA

Active Member
Folks,
Time for question again. Input will be appreciated as always.
I could not find way to mark on spinner to make precise hole for screw on back plate ( the one goes in front has only 4 nuts plate.??)
My spinner is gel coted already, so light wont work.

Any idea. I cant afford to make several hole than I need.
 
The method I used on an aluminum spinner for another homebuil was to slip the front bulkhead in and mark one hole center. I drilled the hole and put in a machine screw and nut to hold it while I match drilled the other three holes using a right angle drill. Then I assembled the hub and both bulkheads, slipped it into the spinner and put four machine screws in the forward bulkhead holes to hold everything in place while I match drilled the rear bulkhead holes.
 
Back
Top