Stockmanreef
Well Known Member
This page tells you to ream a bunch of holes in the bulkhead with a 0.311 and a 0.375 reamer on the F-01403 and F-01404 bulkheads.
On 25-02 it says: "Always ream using a drill press set on a low speed"
well how is one supposed to use a drill press to ream the holes on 25-06 after the cover ribs (F-01438) and the side angles (F-01403D) in place on the F-01403 bulkhead.
The same thing applies to the F-01404 bulkhead.
Maybe I missed something or they notes are supposed to be reamed with a hand drill.
Any advice would be appreciated. I would prefer to not screw up the bulkheads since they are expensive.
thanks
ken
On 25-02 it says: "Always ream using a drill press set on a low speed"
well how is one supposed to use a drill press to ream the holes on 25-06 after the cover ribs (F-01438) and the side angles (F-01403D) in place on the F-01403 bulkhead.
The same thing applies to the F-01404 bulkhead.
Maybe I missed something or they notes are supposed to be reamed with a hand drill.
Any advice would be appreciated. I would prefer to not screw up the bulkheads since they are expensive.
thanks
ken