I've just done my left elevator and have the rivets done along the forward hinge line for the trim tab hinge. In the process the hinge tabs are not perfectly aligned. Some are bent a little back, and one has one side crimped over slightly so the hole is a little small.
Any tips for the best tool or process to get the hinge straightened out? I think the bounce of the bucking bar bent them around during the process. The aluminum of the hinge is very soft.
Any tips for the best tool or process to get the hinge straightened out? I think the bounce of the bucking bar bent them around during the process. The aluminum of the hinge is very soft.