work space / table required?
Im expecting QB Fuselage by end of April. Im working in a two car garage and the space is getting tight. My 1st question is;
I have two work benches along the wall each about 2 feet deep and 6 feet long they will remain. Can i get rid of the large work bench 4' x 8' that i have been using for all big assemblies? Will it still be required as i move on to the fuse? or after? (empenage is completed).
what is required for the building of the QB fuselage. Ive seen some on saw horses and some on a rotisserie?
Lastly does anyone have a pre wing close-up checklist?
Thornhill Ontario Canada
Building RV7 #70770
QB Fuse done
Finish kit underway
Vans Airforce Dues Paid
Flying Piper Supercub PA18 150
Flying Cessna 414A