What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Fuel Tank Calibration

MrSparkle

Member
I've installed a new fuel tank in my RV-12 of which I am not the original builder; what specific documents instruct on how to calibrate the fuel level sensor? A forum search mentions the Skyview System Installation Guide but I have also read reference to the PAP which I believe is the Production Acceptance Procedures. I have the Skyview Installation Guide but not the PAP, is the PAP a separate document from the KAI?

Thanks for your help.

Ian Heritch
RV-12 N417E
8T8 San Antonio, Tx
 
I don't remember any specific document that did that. IIRC, that happens in Skyview Setup. Hardware Calibration > EMS Calibration.
 
Been awhile since I did mine on the D180, but as I recall it was all in the PAP. The Dynon installation manual should cover it.
 
Back
Top