papamike
Well Known Member
Hey guys, I'm adjusting the vertical placement of my latch in the canopy.
I've already cut the tube in the canopy frame to raise the latch arm up toward the pin. My question is, can I bend the arm so it aligns with the pin, or should it stay straight, so I'd have to trim just a bit more off the tube to make it line up?
Edited: Here's what I have. (I didn't have the canopy on when I originally posted this). I think maybe this isn't the big deal I was thinking it was...
I can push the arm up into position. But I'm thinking I should just shave more off the tube and keep the arm straight.
I've already cut the tube in the canopy frame to raise the latch arm up toward the pin. My question is, can I bend the arm so it aligns with the pin, or should it stay straight, so I'd have to trim just a bit more off the tube to make it line up?
Edited: Here's what I have. (I didn't have the canopy on when I originally posted this). I think maybe this isn't the big deal I was thinking it was...
I can push the arm up into position. But I'm thinking I should just shave more off the tube and keep the arm straight.
Last edited: