Fiberglass finished!
Turned out good, not perfect, but good.
There are a few areas where tiny fragments of the line came off with the tape, little chips, hardly noticeable.
There is one "hanging chad" (second pic) that is about 1/2 inch wide and a few 32nds tall at the top of it's ramp. Not sure how to remove this or even if I should or perhaps just let the painter fix it?
Any opinions welcome!
Edit: What looks like scratches on the plexiglass above the line is just dust on the inside.
Turned out good, not perfect, but good.
There are a few areas where tiny fragments of the line came off with the tape, little chips, hardly noticeable.
There is one "hanging chad" (second pic) that is about 1/2 inch wide and a few 32nds tall at the top of it's ramp. Not sure how to remove this or even if I should or perhaps just let the painter fix it?
Any opinions welcome!
Edit: What looks like scratches on the plexiglass above the line is just dust on the inside.
Last edited: