I'm working on installing wingtips. I've followed the directions in section 5 and the joint is flawless. In fact, it is too tight. There is no room for paint. Any thoughts how I can get a nice uniform joint? The post below is a synopsis of the notes in chapter 5. Tape would have been great to use, but it won't go nicely around the radius of the leading edge, so a releasing agent was used.
I used tape on the balance of the joint, but the joint is far too tight for paint. The joint is filled with a dry mix of micro as the joggle was horrible.
Thoughts?
I used tape on the balance of the joint, but the joint is far too tight for paint. The joint is filled with a dry mix of micro as the joggle was horrible.
Thoughts?