Flap position pushrod...
I have my flap actuation system (torque arms and flap crank) ready to install and am working on my flap position pushrod.
Looking at pages 54-02 and 54-04, I'm having a difficult time visualizing the plane of the 45-degree lower bend. I just about have myself convinced that it's exactly the same as the upper 90-degree bend, but figured I'd check first.
If that's the case, is the pushrod sufficiently secure at its lower end? Doesn't seem like much holding it in there...
RV-8 N118KB (sold)
RV-14A #140494 (Fuselage in progress)