Originally Posted by Greg Dillon
Now this is with the assumption that all holes for mounting bolts and screws line up the same.....
yeah, that's gonna be the trick right there - getting the holes drilled in the Z-brackets in the correct location is going to be the fun part.
I would entertain the thought of pulling the existing tank, then laying a piece of scrap aluminum or similar along the original Z-brackets, clamp it in place and backdrill the holes to the scrap with a right-angle drill, then transfer the scrap to the new tank and drill the new Z-brackets. That should get you reasonably close.
Greg Niehues - PPSEL, IFR, Repairman Cert.
Garden City, TX VAF 2019 dues paid
N16GN flying 380hrs and counting! Built an off-plan 9A with too much fuel and too much HP. Should drop dead any minute now.