Nihon_Ni
Well Known Member
I ran into a problem this morning while working on building the release assembly for the inflight adjustable rudder pedals. I'm having a hard time figuring out how a 5/32" wide roll pin (MS 16562-30) will fit into a 3/32" hole in the lock pin (F-8103E). I get that it needs to be compressed by inserting it into the hole in the lock pin, but I can't figure out how to get it started into the hole. Can someone give me a tip on how to get the roll pin inserted?
Thanks,
Rob
[/URL][/IMG]
Thanks,
Rob