I assume the website sends the email to [email protected], but you might want to try sending an email directly to this address. A lot of websites offer "contact us" buttons but then no one monitors the email address to which the message is sent. FWIW, I've had no issues with messages sent to the above address.Has anybody else have any problems getting in touch with Dynon support? I called all last week and each time received "leave a message". So I left a message, no response. I sent an email from their website again, no response.
Maybe one of you know the answer. I have a SV and was wondering if the SV will send fuel/air data to my ifd440. My GRT would send the data to my 430 and it would calculate the burn etc in the flight plan
Maybe one of you know the answer. I have a SV and was wondering if the SV will send fuel/air data to my ifd440. My GRT would send the data to my 430 and it would calculate the burn etc in the flight plan
+1The other item to bear in mind is that the Skyview already performs the functions you are trying to get from the 440. I added the data fields for fuel at waypoint, flight time remaining (at current fuel flow) and one other (destination fuel I think) to the engine display. The Skyview already calculates it all continuously, you just have to tell it to display it for you.
i tried to reach dynon tech support now for weeks. was sending emails and left messages on the voice mail... no response. does anybody know what's going on?
The error message indicates that the update software is not seeing all the devices normally operating on the DSAB network. Make sure all devices are powered up and connected to the DSAB hub.
Once I had everything connected and turned on my updates executed perfectly.