AboveMSL
Well Known Member
Good morning folks,
I know this note on page 33-04, "Tighten the nuts and bolts until they are finger-tight DO NOT use standard torque values," applies to the nuts and bolts attaching the rudder pedals. Does it also apply to the nuts and bolts attaching the brake master cylinders, or should those be torqued to standard values?
Thanks,
I know this note on page 33-04, "Tighten the nuts and bolts until they are finger-tight DO NOT use standard torque values," applies to the nuts and bolts attaching the rudder pedals. Does it also apply to the nuts and bolts attaching the brake master cylinders, or should those be torqued to standard values?
Thanks,