I am wanting to change the battery chip in my VM1000. I found the part number for the battery chip and bought the chip from Newark. Ready to go right? It looks like I will have to remove all the sensor wires and the ribbon cable in order to get the cover off of the DPU. Can this be true? My wiring was done very neatly but it is not labeled so this will be a little bit of a chore. Has anyone tried this task before. Is there something I am missing? Any thoughts would be appreciated.
Thanks in Advance!
Bill York
[email protected]
RV6 N477DH
Stellar Airpark
Chandler AZ
Thanks in Advance!
Bill York
[email protected]
RV6 N477DH
Stellar Airpark
Chandler AZ