Hi Folks.
I noticed that in a couple of spots the edge distance is pretty close to the minimum on part VS-808 the (1/8" thick VS doubler). From what I can tell looking at the Mil Spec for an 1/8", rivet the actual minimum is more generous at 0.219 vs the 2D (.25) rule of thumb.
Anyone else run into this or can confirm that it's ok to use .219" for the edge margin? I have an email in to Vans and figured I'd ask here too.
Thanks.
I noticed that in a couple of spots the edge distance is pretty close to the minimum on part VS-808 the (1/8" thick VS doubler). From what I can tell looking at the Mil Spec for an 1/8", rivet the actual minimum is more generous at 0.219 vs the 2D (.25) rule of thumb.
Anyone else run into this or can confirm that it's ok to use .219" for the edge margin? I have an email in to Vans and figured I'd ask here too.
Thanks.