Just doing a twin G5 install with CAN bus to a single GMU11.
All the wiring appears to be as it should, with GMU11 at one end to single G5 then daisy chained to a second G5 (bare in mind I have quadruple checked the wiring).
Termination adaptors are fitted to the ends GMU11 and the end G5) but not to the mid point node.
One is operating as Attitude (Airspeed, Alt etc) with intention to take data from the GMU11 also, second is DG only also utilising the GMU11. Individually they work done on the CAN bus but as soon as I fit the two on the bus it shows a Network Address Conflict.
Can't for the life of me figure it out.
Any thoughts.
All the wiring appears to be as it should, with GMU11 at one end to single G5 then daisy chained to a second G5 (bare in mind I have quadruple checked the wiring).
Termination adaptors are fitted to the ends GMU11 and the end G5) but not to the mid point node.
One is operating as Attitude (Airspeed, Alt etc) with intention to take data from the GMU11 also, second is DG only also utilising the GMU11. Individually they work done on the CAN bus but as soon as I fit the two on the bus it shows a Network Address Conflict.
Can't for the life of me figure it out.
Any thoughts.