Instrument Panel Drawing?

Does anyone have a CAD drawing of the RV-12 instrument panel they'd be willing to share? Our production manager thought he saw one on the forum here a while back, but we can't find it.

Thanks!
Katie
Jabiru USA

I need one too. Just a blank panel would work, or one with stuff on it that I can modify.

Thanks.

I don't suppose you ever found a drawing? I could use one too. I suppose I may have to drag my butt over to the hangar and actually measure what I need measured. I wouldn't mind if it weren't night, it weren't raining we hadn't seen 800 overcast for the past several days.

KatieB said:

Does anyone have a CAD drawing of the RV-12 instrument panel they'd be willing to share? Our production manager thought he saw one on the forum here a while back, but we can't find it.

Thanks!
Katie
Jabiru USA

Click to expand...

Katie, contact Bill @ Up North Aviation he created my CAD for the panel and cut it out for my GRTs and other avionics



This may be the post you saw with the cad

http://www.vansairforce.com/community/showthread.php?t=84451&highlight=panel

You are welcome to use the dwg I made for my RV-12 one-piece panel. I had three test panels cut on a waterjet before arriving at this layout. Check the hole spacing in the center as I have a couple of extra holes in there. I also made a separate panel for attaching the throttle and parking brake controls, it is attached to the bottom of the F-1202-B panel base so that I can remove the panel without messing with the control cables.

https://dl.dropboxusercontent.com/u/84700540/RV-12_One-_Piece_Panel for N896HS, 20150721.dwg

Final result is here: https://dl.dropboxusercontent.com/u/84700540/P1000691.JPG

I also needed a much larger bracket for my IDF540 and Garmin GTR200 so I designed a new radio bracket. Same attachment footprint as the standard RV-12 brackets. I also added a 1/2x1/2 AL angle running the entire width of the panel base to stiffen it for the weight of IDF540.

https://dl.dropboxusercontent.com/u/84700540/Radio Rack Support Bracket, RV-12 N896HS, 20150611.dwg

I did not use any of the Van's RV-12 electrical/avionics so this panel layout needs to be adjusted if you are using the standard wiring/switches/fuses.

John Salak
RV-12 #120116
N896HS

RV-12 Panel Cad file

The link to John's file is not working. Does anyone have the blank or complete DXF file available?
Thanks,
Frank

I was talking with Randy Lervold about this the other day. I would be happy add this template to my Panel Designer if someone has one to share...