Attachment Holes TYP.?

This is the first time I have seen (attachment holes typical) on 14-08. I searched chapter 5 for definition- no joy. I presume that the hole(s) don?t receive any treatment ( match-drill, final drill , etc.) But, that is an assumption. Probably an easy answer for the experts. Thanks. Jt


http://halie.com/o5S.png

Pretty sure this is;

TYP-----typical.

Used when a detail is repeated lots of times.

Example------if a part was to have a .040" radius on all edges, they would just say "edge radius .040" TYP"