Floor standing drill press

About to start the wings on my -10, so far my bench drill press has been great but unfortunately i cant use it on my spars because of the lack of height between chuck and bottom stand,

have most drilled/cs their spars by hand with the wings? or would you advise the extra ? to grab a floor mounted pillar drill to accomodate the spar. Ive used the press over hand whenever i can on the emp as the finished product always appeared better.

Thanks
James

Countersinks

All done by hand. Not sure if the 10 is the same as the 7 but the longerons also have a gazillion countersinks.