What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

What Hardware is used???

Myrv14

JVL
Sponsor
I’m finishing up on the Aft Fuselage and have a question for those ahead of me. I’ve attached an excerpt from the Vertical Stabilizer section on page 06-04. The plans instruct you to “leave open” one of the rivet holes on the Rudder Hinge Bracket.....I did.

http://photos.app.goo.gl/J4mvLLNNwW6XOgVI3

So, moving on to page 11-07 (excert below) and the Vertical Stabilizer attachment. It shows the use of two AN3-6A and three AN4-6A bolts. However, still doesn’t address the “open” hole in the Hinge Bracket. I also can’t find anything in the plans discussing what hardware (if any) is used on this “open” hole.

http://photos.app.goo.gl/fBb04WEu0akNz6v52

So, does anyone know what’s the deal with this “open” hole? Is it actually left “open” or did I miss something in the plans?

Jason
 
Last edited:
Back
Top