Hi All,
Working on my Outboard leading edges and about to dimple the skins. Before doing the edges that attach to the spar, I?m wondering: ?Should i put a slight bend on the skins using the edge roller tool??
In Section 16 they have you do this for the top forward edge of the skins. But in Seciton 17 there is no mention of the same for the Leading edge skins that will be attached to the main spar.
Maybe at this point they think I should just know to do this?
Have you all done this?
Regards,
Rich K
Working on my Outboard leading edges and about to dimple the skins. Before doing the edges that attach to the spar, I?m wondering: ?Should i put a slight bend on the skins using the edge roller tool??
In Section 16 they have you do this for the top forward edge of the skins. But in Seciton 17 there is no mention of the same for the Leading edge skins that will be attached to the main spar.
Maybe at this point they think I should just know to do this?
Have you all done this?
Regards,
Rich K