Autopilot install pre molex connectors

Does anyone have a link to the instructions showing the autopilot install with the spade connectors instead of the molex?

Also, anyone recall what wires need switched for the AP disconnect button for the skyview conversion harness setup ?

Thanks !

44-04 Rev. 1

Page 44-04, link to the page on Van's website.

Thanks Tony !

About swapping pins. I have a call into vans and Dynon awaiting their thoughts. Seemed to vans that this only affected a few airframes and a couple pins do need swapped.

Skyview with the conversion harness
Autopilot engages and calibrates but just get these network errors.

Thoughts on pins to swap? There may have an SB but i don't seem to see it.

Looking at Van's schematic SkyView-Prior-08-25-11, the OPTIONS D-Sub connector on the AV-50000A. The most likely wiring error is that pins 3 & 4 are reversed.

Thanks joe. It was pin 3/4 on the options plug that goes into the AV5000. All works well. !!!!