I am using the GTN 6xx / 7xx STC Installation Manual, Rev. 11
My configuration is a GTN 650 to GAD 29 to G5 HSI and G5 AI and GMU11.
The installation manual, page E-52, figure E-20, shows P1001, pin 39 as the CDI source select connected to a momentary push button switch. The associated NOTE 3 refers the reader to Section 2.4.8 for additional information.
There is no Section 2.4.8 in this manual and I can not find where this information might have been placed anywhere else in this manual. Can anyone at Garmin tell me what is contained in Section 2.4.8
Thanks
My configuration is a GTN 650 to GAD 29 to G5 HSI and G5 AI and GMU11.
The installation manual, page E-52, figure E-20, shows P1001, pin 39 as the CDI source select connected to a momentary push button switch. The associated NOTE 3 refers the reader to Section 2.4.8 for additional information.
There is no Section 2.4.8 in this manual and I can not find where this information might have been placed anywhere else in this manual. Can anyone at Garmin tell me what is contained in Section 2.4.8
Thanks