all, I've read about cables being too short - but have any of you builders encountered too long HS cables? Mine are threaded into the turnbuckles (not all the way yet, but no thread is visible) and they're still quite loose. They do not slam the cone, nor each other. When applying UP or DOWN however and the HS reaches its stop the HS keeps nodding a bit for there is too little tension on the non-pulling cable.
I haven't measured the tension yet and am still in the process to remove the ground plate under the seats to check the right position of the cables on the pulley's, but according to pics I'm almost certain that part of the build is being done OK.
Just curious for someone else having too long cables?
I haven't measured the tension yet and am still in the process to remove the ground plate under the seats to check the right position of the cables on the pulley's, but according to pics I'm almost certain that part of the build is being done OK.
Just curious for someone else having too long cables?