hi all,
i have plumbed 2 planes and never run into a problem with my judgement. in my mind what i am going to describe is fine in my application but i am always afraid i don't know what i don't know.
my fuel system of teflon and braided s.s. ends at an inline cartridge filter that is mounted to a bracket by 2 adel clamps. filter is attached by 3/8'' alum. tube to the fuel tank . alignment of fuel filter to fitting of tank is good and tubing is pretty much a ''straight shot''. the run of straight tubing is 2 1/2''. should i have any concerns about this short run of alum. tubing? filter and tank securely mounted to airframe.
thanks for any experienced opinions.
i have plumbed 2 planes and never run into a problem with my judgement. in my mind what i am going to describe is fine in my application but i am always afraid i don't know what i don't know.
my fuel system of teflon and braided s.s. ends at an inline cartridge filter that is mounted to a bracket by 2 adel clamps. filter is attached by 3/8'' alum. tube to the fuel tank . alignment of fuel filter to fitting of tank is good and tubing is pretty much a ''straight shot''. the run of straight tubing is 2 1/2''. should i have any concerns about this short run of alum. tubing? filter and tank securely mounted to airframe.
thanks for any experienced opinions.