I am a Wittman Tailwind owner with no RV building experience and have an opportunity to buy a ground looped RV-6. The damage to the airframe includes a wing which most likely has a bent spar. I have purchased the plans CD and thought that I could buy a used wing or a wing kit which someone had not finished to replace the bent spar wing. As I have searched this forum for info on the RV-6 wing removal it became clear that the wings were going to be difficult to remove due to the close tolerance bolts. I also understand that the spars and center section are all match predrilled together at the factory. I am starting to wonder if it will be possible to install a different wing in place of the bent spar wing. Can any of you give me any experiences you have had with this issue? Is it possible to just replace one wing? Is the only fix to install two new wings with a match drilled center section? Any light you can shed on this to keep me from making a mistake is greatly appreciated.
Dave
Dave