I am getting ready to rivet the midfuse lower skin. I have been diligent in making sure I dimpled the F-1015 and F-1018 webs as they are not clearly defined in the plans, but looking ahead you realize there needs to be AN426AD-3 there later on. Also a huge shout out to Justin and Ed for mentioning that on their build logs.
But...
What about the attachment of the F-1018, F-1021 and the F-1034 bulkhead? There are two "keeper rivets" that need to go in. Yet in page 26-5 step 6 it clearly states to. ...dimple all EXCEPT the aft row of holes in the F-1018 which would be the ones for the keeper rivets. I have scoured the plans and can not find how these holes are dealt with.
Any help would be appreciated
But...
What about the attachment of the F-1018, F-1021 and the F-1034 bulkhead? There are two "keeper rivets" that need to go in. Yet in page 26-5 step 6 it clearly states to. ...dimple all EXCEPT the aft row of holes in the F-1018 which would be the ones for the keeper rivets. I have scoured the plans and can not find how these holes are dealt with.
Any help would be appreciated