rleffler
Well Known Member
I've had my tracker for over two years, but I'm not just getting flying. It came preconfigured, so I've not changed anything from it's original configuration.
When checking the site to look for data from my second flight, I was surprized to see this. Can somebody assist me in educating me on what is needed to be done to resolve this?
thanks,
bob
Device:Byonics: TinyTrak3 (tracker)
Last path:N410BL>T0QU3T via WIDE2-1,qAR,KD8PHI-1
This station appears to be flying at high altitude and using digipeaters, which causes serious congestion in the APRS network. The tracker should be configured to only use digipeaters when at low altitude.
When checking the site to look for data from my second flight, I was surprized to see this. Can somebody assist me in educating me on what is needed to be done to resolve this?
thanks,
bob
Device:Byonics: TinyTrak3 (tracker)
Last path:N410BL>T0QU3T via WIDE2-1,qAR,KD8PHI-1
This station appears to be flying at high altitude and using digipeaters, which causes serious congestion in the APRS network. The tracker should be configured to only use digipeaters when at low altitude.