Nav/strobe/landing/taxi terminal block

Can someone please give me some guidance on how to split the various wires out to the respective wing tips and tail. At the moment I have the main wires from the switches bundled together terminating under the pilot seat. Just not sure where to go from there.

Many thanks

Stein sells some terminal blocks that work great for that.

I was planning on just putting two wire on each switch one for the left and one for the right wing. For my landing lights I have double pole switch so if one switch failed hopefully I would still have one landing light. For the strobes I was going to put the strobe power supply in some TBD location in the center of the plane and route the wires for the supply to the tail and wings.

thanks

Stein blocks it is. Just what I needed, thanks