Dynon SV roll servo question

Janekom

Well Known Member

Patron

• Sep 12, 2016

• #1

I have hear that the SV32 servo might be a bit weak to be used as the roll servo on the RV10. Anyone with advice or experience wit this please. I have used the SV42 once before on a 10 but now have a SV32 that I would like to use as the roll servo. Thanking you in advance.

 

WA85

Well Known Member

• Sep 12, 2016

• #2

I had a roll servo SV-32 that would constantly slip in an RV-9A. I contacted Dynon and they recommended using the SV-42 servo for RV-9A roll applications. They also exchanged the 32 for a 42 at no cost.

 

Janekom

Well Known Member

Patron

• Sep 12, 2016

• #3

Thank you - can you remember which hole you have used on the arm?

 

P

paul330

Well Known Member

• Sep 13, 2016

• #4

Jan

It's definitely the SV42 that is recommended for the -10. IIRC, they say to use the outer hole but it is in the install manual - somewhere......

 

Janekom

Well Known Member

Patron

• Sep 14, 2016

• #5

Thank you very much - SV42 it will be then