Hi all,
I?m new in this forum. After several months spent to investigate and get proper authorizations, I?m now an official italian RV10 builder.
I have a question about dimpling machine.
At the moment I?m completing my work table, with a simil-drdt2 installation, like many other I saw.
I was thinking that for daily usage, it is easier to place the dimpling head not too much near to the table edge. Especially for big skin sheets, probably it is a good think to work a little far from the edge so to keep the sheets planar as much as possible.
The issue I see is if it is necessary to dimple ?not planar? sheet, where it could be not possible to use such kind of machine configuration, suggesting to put the dimpling head near the border.
What do you suggest about the position of the dimpling head?
Any other suggestions you would consider for building this tool?
Thanks a lot; this is a great community.
Francesco
I?m new in this forum. After several months spent to investigate and get proper authorizations, I?m now an official italian RV10 builder.
I have a question about dimpling machine.
At the moment I?m completing my work table, with a simil-drdt2 installation, like many other I saw.
I was thinking that for daily usage, it is easier to place the dimpling head not too much near to the table edge. Especially for big skin sheets, probably it is a good think to work a little far from the edge so to keep the sheets planar as much as possible.
The issue I see is if it is necessary to dimple ?not planar? sheet, where it could be not possible to use such kind of machine configuration, suggesting to put the dimpling head near the border.
What do you suggest about the position of the dimpling head?
Any other suggestions you would consider for building this tool?
Thanks a lot; this is a great community.
Francesco