Burtonport
Member
On page 6-02 of the vertical stabilizer plans there are 2 bearings, com-3-5, that are supposed to insert in the hinge spacers VS-1211A and B. In the HomebuiltHELP video they pop right in. My arthritic old fingers are not able to make them fit. Am I supposed to scrape out some material in the spacers to help them fit?
I was going to ask Van's this question tomorrow morning but I would like to find out today, and besides, you guys need to get used to my stupid questions.
I was going to ask Van's this question tomorrow morning but I would like to find out today, and besides, you guys need to get used to my stupid questions.