What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

W-710 wing root rib to F-776 bottom fuse skin screw location

TX7A

Well Known Member
In preparing to attach wings, instructions say to mark unused rivet hole locations of rib flange as a guide for drilling screw holes in F-776 bottom center fuse skin. Problem is, I have QB wings and ALL rivet locations on bottom side have rivets in them. The top of the wing has the required empty rivet locations evert third hole. I I need to know which rivets to drill out on the bottom side for the screw locations. (Between the main spar and the rear spar.) I have looked the plans over and can't find the specific location call-out.

Thanks for you help.

Sam
 
Last edited:
check out the drawing one more time... it shows the bottom wing skin and rivet callout there. if you look at it carefully, you'll notice that they show which holes not to rivet.
 
Thanks Radomir.

I don't know how I missed it, but there it was. Guess it was late when I was trying to figure it out.

Sam
 
Back
Top