My Skyview is not showing my trim position. All I see is a blank graph. My trim is working fine. I am just not seeing it on my Skyview screen.
I checked that all the wires are in the correct position in the plug at the control module. I see 5V in the Wht/Blu wire, ground in the Wht/Orn wire and 0 to 5 volts in the Wht/Grn (position wire). I have measured the voltage at the servo and the control module. Everything seems to be fine up to the module.
Do I have to program the Skyview to read it or do I have a problem somewhere?
I?m almost done and this has me stumped
I checked that all the wires are in the correct position in the plug at the control module. I see 5V in the Wht/Blu wire, ground in the Wht/Orn wire and 0 to 5 volts in the Wht/Grn (position wire). I have measured the voltage at the servo and the control module. Everything seems to be fine up to the module.
Do I have to program the Skyview to read it or do I have a problem somewhere?
I?m almost done and this has me stumped