vfrazier
Well Known Member
Formerly found in:
http://www.vansairforce.com/community/showthread.php?t=154557&page=5
Moved here due to thread drift.... this topic deserves a home of it's own.
One of our builders modified his flap torque tube to fit beneath the floor. Here's his description:
Here's my flap torque tube--it runs under the floor. I measured incorrectly and have a small 1/2" or so bump in the floor for the top portion of the 970 washers I used. Just
saw the Tom Martin post. You can use these if you would like to post them, just identify me as "one of your builders". Close enough. 300 hrs, no problem. The arms are adjustable because this was the
prototype, but if I were to do it again I would make them fixed.
http://www.vansairforce.com/community/showthread.php?t=154557&page=5
Moved here due to thread drift.... this topic deserves a home of it's own.
One of our builders modified his flap torque tube to fit beneath the floor. Here's his description:
Here's my flap torque tube--it runs under the floor. I measured incorrectly and have a small 1/2" or so bump in the floor for the top portion of the 970 washers I used. Just
saw the Tom Martin post. You can use these if you would like to post them, just identify me as "one of your builders". Close enough. 300 hrs, no problem. The arms are adjustable because this was the
prototype, but if I were to do it again I would make them fixed.