gonzaviador
I'm New Here
Hi guys. Once again I'm looking for your wisdom because I made a mistake.
The mistake I made was while fitting the right side skin to the center section of the fuselage in preparation for riveting. I didn?t recall that the F-704H was flat on the inside and by mistake countersunk the holes of the rivets (the -3 ones) of the vertical "legs" of the F-704C and D of the right side.
Is acceptable to carry on or should I replace both F-704C and D?
Maybe I could use -4 rivets (Ups rivets) instead the original -3... Or add a strip of aluminum behind the whole structure... or both...
Please advice...
Thanks a lot!
The mistake I made was while fitting the right side skin to the center section of the fuselage in preparation for riveting. I didn?t recall that the F-704H was flat on the inside and by mistake countersunk the holes of the rivets (the -3 ones) of the vertical "legs" of the F-704C and D of the right side.
Is acceptable to carry on or should I replace both F-704C and D?
Maybe I could use -4 rivets (Ups rivets) instead the original -3... Or add a strip of aluminum behind the whole structure... or both...
Please advice...
Thanks a lot!