Hi,
I am wondering what depth of c-sink should I use on trailing edges E-01423L-R. So far I set depth to about .007" below the surface and it doesn't seem like it's enough for dimple to fit properly. The reason I used 0.007" is that on a wedge style trailing edge such as rudder any deeper than 0.007" seems to start making pilot hole larger and making it oval.
Any advice will be appreciated
I am wondering what depth of c-sink should I use on trailing edges E-01423L-R. So far I set depth to about .007" below the surface and it doesn't seem like it's enough for dimple to fit properly. The reason I used 0.007" is that on a wedge style trailing edge such as rudder any deeper than 0.007" seems to start making pilot hole larger and making it oval.
Any advice will be appreciated