Jumped first; questions later?
I just finished installing the hinges using Mike's excellent directions. I've put off figuring out how to install the ribs and secure the pins. I guess I was thinking it was necessary to rig the ailerons and then match the wingtip T.E.'s to them, and lock in any necessary twist by installing the ribs at that time.
If nothing else, this thread makes me think I should have looked ahead a little more at the rib installation - although this is probably an area where one could "wing it" and depart from the plans a bit without issue, as long as the wing tip closure and hinge pin capture is engineered soundly.
Hop-Along Aerodrome (12VA)
RV-6A - N30YD - flying since '98
RV-10 - N130YD reserved - under construction
donating monthly to the VAF - thanks, Doug