Having a bit of trouble trying to figure out how to get the Molex connector below to fit in the allotted slot. Right now the connector is significantly too small. See pictures below. The plans picture comes from page 19-02. I have a roughly 1/4" gap between the connector and the length of the hole. Both harnesses are this way.
I've viewed a couple of web sites (E's and Shawn aka: Mudfly) and it looks like their connectors fit perfectly. I purchased additional connectors three different times as I'm planning to build my own harnesses since Van's harnesses came up short and the connector doesn't fit. Unfortunately, no matter what I try I can't find a connector to fit in the slot.
In speaking with Van's tech, I was told that the other side of the harness (WH-000125 not provided) would fill the gap or just to fill it with RTV. Filling with RTV is absolutely out of the question. So, I called Stein, ordered the connector that goes on WH-00125....no luck with the fit. A picture of the connector that comes with WH-000125 is shown in picture #3 along with the original harness and the Molex connector that was ordered based on other web sites.
I'm hoping some of you here can tell me what you did to get the right connector or what I'm doing wrong.
Many thanks,
Fred
I've viewed a couple of web sites (E's and Shawn aka: Mudfly) and it looks like their connectors fit perfectly. I purchased additional connectors three different times as I'm planning to build my own harnesses since Van's harnesses came up short and the connector doesn't fit. Unfortunately, no matter what I try I can't find a connector to fit in the slot.
In speaking with Van's tech, I was told that the other side of the harness (WH-000125 not provided) would fill the gap or just to fill it with RTV. Filling with RTV is absolutely out of the question. So, I called Stein, ordered the connector that goes on WH-00125....no luck with the fit. A picture of the connector that comes with WH-000125 is shown in picture #3 along with the original harness and the Molex connector that was ordered based on other web sites.
I'm hoping some of you here can tell me what you did to get the right connector or what I'm doing wrong.
Many thanks,
Fred
Last edited: