I am putting together my F-789 pushrod, but run into couple issues:
1. The Threaded Rod End (AN490HT11P) does not fit the pushrod. I assume I can sand down the threaded rod end until it fits into the pushrod, correct?
2. When I tried to thread the threaded rod end into the Rod End Bearing F3514M, it only went in about 1/4". I then tried an AN316-5 Nut and it only went on the rod end about 1/8". It appears the threaded portion of the rod end is too big. I have no idea how to resolve this issue. Suggestion?
Thanks in advance,
Robin
1. The Threaded Rod End (AN490HT11P) does not fit the pushrod. I assume I can sand down the threaded rod end until it fits into the pushrod, correct?
2. When I tried to thread the threaded rod end into the Rod End Bearing F3514M, it only went in about 1/4". I then tried an AN316-5 Nut and it only went on the rod end about 1/8". It appears the threaded portion of the rod end is too big. I have no idea how to resolve this issue. Suggestion?
Thanks in advance,
Robin