I?m assuming you shifted from a mag to the pMag. If so, did you use the same wire for tach input and if so, did you remove the inline resistor needed when using a mag to feed the Dynon?
My tach wire from Stein was a shielded wire. Initially, I removed the insulation and the shielding, but did not get a tach reading. It turned out, the tiny inner wire also had insulation. Once I removed that, everything worked. Easy fix, if you have the same issue.
I?m assuming you shifted from a mag to the pMag. If so, did you use the same wire for tach input and if so, did you remove the inline resistor needed when using a mag to feed the Dynon?
I?m assuming you shifted from a mag to the pMag. If so, did you use the same wire for tach input and if so, did you remove the inline resistor needed when using a mag to feed the Dynon?