On page 25-3. Did step 2 and when I put it on the center section it didnít fit properly with the bolts through it. The landing gear mount is ever so slightly off and some bolts wonít go through. Can I drill from the othe side to make it fit?
Welcome to the dreaded landing gear mount. I had the same issue. I took a AN-14 bolt and made a drift pin to help encourage the bolt holes into alignment. A rubber mallet is essential along with a few curse words
Dr. Mark Ciaglia
The Woodlands, TX
Donating Monthly since 10/17
N189PT- Christen Eagle II
N627DG (reserved)- RV10 in the making www.marksfamilyrv10.wordpress.com