VansAirForceForums  
Home > VansAirForceForums

- POSTING RULES
- Donate yearly (please).
- Advertise in here!

- Today's Posts | Insert Pics


Go Back   VAF Forums > Model Specific > RV-12
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 09-20-2018, 05:32 AM
STEVEM STEVEM is offline
 
Join Date: Jan 2005
Posts: 39
Default RV12is Oil Tank Bracket modification

Has anyone received a kit from Van's that included two steel brackets with instructions for modifying the F-01201 oil tank/battery box brackets? The instructions that came with the brackets (F-00194) are not clear about trimming off the semi-circular extensions on the F-01201.
Reply With Quote
  #2  
Old 09-20-2018, 11:59 AM
subpar_bucker subpar_bucker is offline
 
Join Date: Oct 2016
Location: Cranberry Twp, PA
Posts: 17
Default

I have received the same update. I haven't installed it yet, but I did trim out the pattern and test fit it. Didn't look right - then I realized Van's as updated this section of the plans and I was looking at the older revision. Look at page 9 here:

https://www.vansaircraft.com/pdf/rev...2iS_29iS-U.pdf

I think that helps to visualize what needs to be removed. In particular the circular notch in the F-01201E's needs to be enlarged/moved further back towards the firewall (I was trying to line up the notch in the pattern with the existing notch, and that didn't work).

If you look at what needs to be cut from behind, I think you'll see the mating portions of the F-01201E's - and likely the trimming needs to match up to these lines and not remove any more of the F-01201E than just the large tabs.
Reply With Quote
  #3  
Old 09-20-2018, 12:12 PM
STEVEM STEVEM is offline
 
Join Date: Jan 2005
Posts: 39
Default

Thanks. I think you're right, based on the drawing. I did reach out to Van's support on this one, but haven't heard back. I'll post their response.
Reply With Quote
  #4  
Old 09-21-2018, 05:01 AM
STEVEM STEVEM is offline
 
Join Date: Jan 2005
Posts: 39
Default

Apparently, the curved extension does get trimmed off. Here is the response that I received:

"As near as I can tell the curved flanges are now cut off even with the edges of the F-01201G."
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -6. The time now is 05:01 PM.


The VAFForums come to you courtesy Delta Romeo, LLC. By viewing and participating in them you agree to build your plane using standardized methods and practices and to fly it safely and in accordance with the laws governing the country you are located in.