I need some help with the interface of the FS 450 and my 496. I have followed the instructions on the JPI website but can't seem to get the 450 to show REQ or RES. The lights don't even come on. Has anyone had success with this set up? Do I have to do anything on the 496 to get it to push the data to the FS450? I have set the destination and activated the flight plan, guidance starts and drives the autopilot.
Info from the JPI website:
Interfacing the FS 450 with a Garmin ? GPSMAP 196/296/396/496:
The FS 450/460 (Twin) and the Garmin 196/296/396/496 must share a common ground
No EDM programming needed
RS232 Output ?> NMEA-183 Out
https://www.jpinstruments.com/technical-support/gps-interface-connections
Thanks for your help.
David
Info from the JPI website:
Interfacing the FS 450 with a Garmin ? GPSMAP 196/296/396/496:
The FS 450/460 (Twin) and the Garmin 196/296/396/496 must share a common ground
No EDM programming needed
RS232 Output ?> NMEA-183 Out
https://www.jpinstruments.com/technical-support/gps-interface-connections
Thanks for your help.
David