What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Sealing holes in sheet metal around penetrations?

Status
Not open for further replies.

Kooshball

Well Known Member
I don?t (yet) have an RV but in tracking down cold air drafts I have found areas where fuel lines (at the fitting) pass through the fuselage behind the wing fairing. I would like to fill the holes but since a fitting is there I don?t think RTV is appropriate.

Any thoughts on what I should use for this application?

Thx.
 
Status
Not open for further replies.
Back
Top