Had a small set back this evening on my top engine cowl. I installed the cowl inlets with epoxy and cotton flox mixture , clecoed everything in place and installed the top cowl as per instructions.
That's what I did, what I did not do was check after everything was in place to see that the clecoes were still holding properly. Obviously three let go on one side creating a cured mess.
I managed to clean things up and redo that side.
That's what I did, what I did not do was check after everything was in place to see that the clecoes were still holding properly. Obviously three let go on one side creating a cured mess.
I managed to clean things up and redo that side.
