Drawing 27A, Section C-4, Vertical stabilizer the plans call for a AN3-6 bolt on the left side with a washer superglued to AFT side of stop.
Does anybody have a picture of where this washer goes exactly. I am 99% sure I got it correct. I have a washer between the elevator stop and the vertical member of the tail on the left side only.
Just be nice to see a picture or verify 100% this is correct before I finish buttoning up the tail mounting.
Does anybody have a picture of where this washer goes exactly. I am 99% sure I got it correct. I have a washer between the elevator stop and the vertical member of the tail on the left side only.
Just be nice to see a picture or verify 100% this is correct before I finish buttoning up the tail mounting.