So I searched the plans and did a search here but I can't find an answer that is definitive.
On the VS drawing it lists 6 places on each side of the lower VS skin with X's and says to leave them open for the Empennage Fairing. I've figured out this will be in the Finish Kit, part # F-794B. However, I can't find a reference to it anywhere in the plans, even though I scoured the fuse section and the stuff in the canopy, landing gear, etc. sections.
My question is simply this: Should I dimple these holes or leave them as is? Does it matter?? Thanks in advance for any assistance! You guys have been a big help already!
On the VS drawing it lists 6 places on each side of the lower VS skin with X's and says to leave them open for the Empennage Fairing. I've figured out this will be in the Finish Kit, part # F-794B. However, I can't find a reference to it anywhere in the plans, even though I scoured the fuse section and the stuff in the canopy, landing gear, etc. sections.
My question is simply this: Should I dimple these holes or leave them as is? Does it matter?? Thanks in advance for any assistance! You guys have been a big help already!