alpinelakespilot2000
Well Known Member
For the tailwheel versions...
On the forward F904C center section bulkhead (probably the equivlant of F704C for the 7's) there are 5 holes left open to attach the main gear weldments for the trigear versions. I can't find any callouts in the plans about what bolts to put in these holes if we are building the tailwheel version. I assume we don't leave these holes open (?). Do we just use the same bolts for the trigear (with extra washers) or go down a bolt size or two? Any reference to this in the plans or drawings that I might have missed?
Thanks.
On the forward F904C center section bulkhead (probably the equivlant of F704C for the 7's) there are 5 holes left open to attach the main gear weldments for the trigear versions. I can't find any callouts in the plans about what bolts to put in these holes if we are building the tailwheel version. I assume we don't leave these holes open (?). Do we just use the same bolts for the trigear (with extra washers) or go down a bolt size or two? Any reference to this in the plans or drawings that I might have missed?
Thanks.
Last edited: